How To Fix Broken Microphone on Jabra Evolve 75

For those that haven’t already figured it out, there’s a short, fray or break in the mic wire running to the PCB. Here’s an awesome YouTube vid that goes over the issue and how to fix it. It’s not hard but will hake some steady hands. It’s way too bad that u/JabraSupport released something with such a bad design flaw.

Things you’ll need:

• T4 Torx Screwdriver for Electronics Repair: https://amzn.to/3r8erbZ

  • This is needed to get the ear pice off
• T6 (T6H) Torx Screwdriver is needed to take out the inner screws, I just recommend this set: https://amzn.to/3uPrvoy

• Soldering iron: https://amzn.to/45HWBM2

• Flux & Solder: https://amzn.to/46444oy

• Donor blank PCB board: https://amzn.to/44IfGwm

• Tiny wires that can run from the Evolve 75 PCB to the donor PCB bits

• Glue

• Mini heat gun like this: https://amzn.to/45HVZGe

Here’s the video I like most.

Here’s a second video though I like the first better.

Here’s a another guide to fix them thanks to u/mrmihai809, https://www.reddit.com/r/Jabra/comments/ifr8w8/comment/go0jhjc/?utm_source=share&utm_medium=web2x&context=3